Aerospace series. Washers, lock, with radial serrations in alloy steel, cadmium plated for flight control rods. Dimensions

BS EN 71-11 specifies methods of analysis to enable assessment of compliance with the chemical requirements specified in EN 71-9 when toy and toy material extracts have been prepared according to the sampling procedures in EN 71-10

Specifiers need to define BS EN 12273 categories for properties relevant to the particular end-use of the slurry surfacing and microsurfacing

which are fundamental to its application

Alloy designations

This international standard specifies a scheme for digital signature of messages of limited length

The purpose is to define test methods in order to determine strength and impact strength of the welded joint when testing welding consumables with single-run and two-run technique

Weldable structural steels are the steels that rely on quench and temper heat treatment to obtain very high strength are more susceptible to welding problems and require specific metallurgical expertise

This document is applicable to any organization with one organizational structure as well as for two or more organizations that choose to work together while continuing to use their own organizational structure or to use a combined organizational structure

The BS ISO 20474 series will also help UK manufacturers into other markets

Manufacturer of zinc alloys

Summary of rms-granularity characterization parameters

BS EN 755-7:2008 supersedes BS EN 755-7:1998