DSN-DVM-368 Digital Voltmeter Module 4.5V-30V DCDSN DVM 368 Digital Voltmeter Module 4. 5V 30V DC is a small & lightweight device. It has three terminals; one voltage input for measuring, one supply voltage and one ground. There are total 4 PCB jumpers on the board, J1 is used to set 2 wire or 3 wire mode and J2, J3, J4 are used to adjust the sensitivity or measuring range. The default jumper used is J3 with a 510K resistor. Specification Supply Voltage 4. 5V to 30V DC Measurement Range 0 30V DC

These are Carbon Film Resistor with a value of 560 ohm 1/8W and tolerance of ±5%

Clearing All Stored Transmitters:Push the learning button on the receiver 8 times

These are Carbon Film Resistor with a value of 200 ohm 1/8W and tolerance of ±5%

That is the current should always flow from the anode to the cathode

Distributed Power Architecture

meaning that it also reduces any leakage current

The chip cascade number is not limited by signal transmission because of auto reshaping transmit technology

Resistance Value 22 ohm Color Code Red

This 2 Pin Screw Type PCB Terminal Block - 3mm Pitch ZB003 is a Pluggable Screw Terminal Block with a compact and versatile design

The regulator is designed to minimize the number of external components to simplify the power supply design

After receiving a low voltage reset signal

(ASYNCHRONOUS PARALLEL OR SYNCHRONOUS SERIAL INPUT) Switching of PARALLEL operation and SERIAL operation is achieved by P/S CONTROL input