Water Detect click - MikroElektronika Leakage Alarm SensorWater Detect click MikroElektronika Leakage Alarm Sensor Water Detect click is used for detecting water and other electroconductive liquids. If the detection area is wet the output of Microchip's MCP606 CMOS op amp will go positive, signaling the presence of liquid. Water Detect click can be used as a household flood alarm sensor, rain detector for smart buildings or for water tanks that act as a limit switch for a pump. You could use it on one of our

and keep them organised

Stretch click Examples

Casing material

The module has low power consumption modes

Analog Sensor Compatible

it can still cycle between sleep mode (120 microamps) to active mode (37 miliamps)

Dimension: 39mm x 50mm

An input signal of 10mV should be applied to the input

up to the SMA connector indefinitely

Getting Started with BlueBee 4

Plug in one of our many VINT-enabled Phidgets that perform a wide variety of functions

mikromedia HMI 5" - MikroElektronika Smart Color Display