Fasteners. Ends of parts with external ISO metric thread1 Scope This International Standard specifies the form and dimensions of ends of parts with external ISO metric screw thread (e. g. bolt, screw and stud ends) recommended for use. They apply to standardized or non standardized threaded parts. For each end type, a symbol is specified and it is intended that these symbols be used when specifying one of the ends for threaded fasteners.

starting and run-up requirements and lumen maintenance requirements which allows them to effectively manufacture and test self-ballasted lamps

you can enhance the efficacy of the radionuclide identification devices and manufacture a standardized product

— general requirements on 48 V DC electrical systems

BS EN ISO 10942:2006 replaces BS EN ISO 10942:1998

GeneratingUnit and SynchronousMachine to model

which are shared by gas turbines with other technologies

Regulators and enforcers including building control bodies

En 88-1 and en 88-2

the track layout

Apparatus for descent velocity and temperature increase test

High wet adhesion

BS EN 1708-2 does not promote the standardization of connections that may be regarded as mandatory or restrict development in any way