Code of practice for falseworkBS 5975: 2006 gives recommendations for the design use of falsework on construction sites. This code has drawn together all those aspects that need to be considered when preparing a falsework design, and in so doing has included recommendations for material, design and work on site. Because the success of falsework is closely tied up with its management, this code also describes procedures as well as technical aspects.

ISO 22282-5 defines the terminology and the measured parameters

goods only lifts

Use and handling of sulfur hexafluoride (SF6)

• Chemical requirements

4 Specimen condition

This part of BS EN 61000 determines the reaction of equipment under test (EUT) to surge voltages caused by switching and lightning effects

Users of textile machines

“pipe” as used in this standard covers other cylindrical bodies such as tubes

Use of this standard should lead to safer products being produced and specified

Deviations from the recommended criteria should occur only after careful consideration

ISO 11124-3 is the third part of ISO 11124 multi-series and discusses high-carbon cast-steel shot and grit

4 Properties of conductor