Mikrotik RB5009 Router and Arris S33/S34 Modem Rack Mount3D Printed rack mount that can combine your Mikrotik RB5009 Router and Arris S33 or S34 Cable Modem into a standard 19 Inch rack, only taking up 1RU! The mount is omni directional, so you can choose which side you want the Router on. The Mount comes pre assembled. To install your Router and Modem, simply remove the rear brackets and slide your devices into place then screw the Rear Brackets back in. Also incorporates 2 Sockets for Keystone Jacks (Not

If you don't need the Keystones

The Switch slides into the frame from the back after removing the back plate

Optiplex 70X0 Micro Series

3D Printed rack mount that lets you mount your Lenovo M Series Tiny form factor PC (M910/920q

The Amp slides into the frame from the front and has a snug fit

NOTE: You will need to pair this with another ModMount item (Like 2 Blanking Plates) to make a full 2RU Width

3D Printed rack mount that lets you mount a Sonos AMP (Not the older Connect:Amp) and Intel NUC (Tall models) next to each other in 2RU

Includes both arms and screws for fixing them to the Switch 8 150

Also incorporates 2 Sockets for Keystone Jacks (Not included)

The printing/manufacturing and postage was very fast

3D Printed 1RU rack mount for the TP Link Omada Controller (OC-200) and a RaspberryPi 4

EliteDesk 705 G3 - G5