Plastics and rubber machines. Injection moulding machines. Safety requirements1 Scope This document specifies the essential safety requirements for the design and construction of injection moulding machines for the processing of plastics and or rubber and provides information for their safe use. This document is applicable only to injection moulding machines with hydraulic and or electrical drives for platen movement. This document deals with all significant hazards, hazardous situations and events relevant to injection

1 Material

NC routing machines and NC combined boring/routing machines

other than a light displayed on an aircraft

BS 5839-8 gives recommendations for the design

— illustrates how other International Standards can be used to support successful implementation of ISO 37101

It is not applicable to die grinders where the inserted tool is mounted in a collet

and polyester strapping

Textile machines are used in the fabrication and processing of fabrics

EN 10088-3:1995

ISO 19642-4 gives testing parameters for the electrical and mechanical tests which can be used by cable and vehicle manufacturers to make better quality cables

ISO 16773 describes a procedure for the evaluation of protective anticorrosion coatings by using electrochemical impedance spectroscopy (EIS)

It allows the determination of the concentration levels that result in an abnormality in embryo-larval development