Collets set | 5 µm | ER11 | stainless steel 4008 ESPRustproof Stainless steel 1. 4021 x 20Cr13 HRC 43 47 Longer lived than standard collets Higher repeat accuracy Maximum concentricity <0,005mm Honed collet boring Especially suitable fore wire EDM

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance1

For safe clamping of taps in end mill holders according to DIN 1835 B

With drivers

800 N/mm² after DIN

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance3

Without wrench

Application:

With clamping screw

Minimal length compensation on compression and expansion balances very small pitch differences between synchro spindle and tap

• runout accuracy: = 0

For machining centres with synchronous spindle

Only nominal size d can be clamped