Attiny85 Micro-USB moduleIf you want to embed a microcontroller into a project and are looking for something smaller and cheaper than an Arduino and you dont need a lot of I O pins or code space, the ATtiny85 can be a good solution. Pin Configuration Power The module can be powered off the USB connector as with any Arduino boards that have USB connectors. USB Interface The module uses pins 3 & 4 for USB communications. I2C Interface The I2C interface is connected to pin 0

Product Type Heat shrink tubing or heat shrink tube Voltage Rating Up to 600V Temperature Rating Up to 125°C Flammability VW-1 Colour Red Diameter 6mm Length 4 Meter Material Polyolefin

These are Carbon Film Resistor with a value of 220k ohm 1/4W and tolerance of ±5%

These are Metal Film Resistor with a value of 22 ohm 1W and tolerance of ±5%

and it is the place where a resistor should be installed for the protection of the LED

Fully compatible with the PC

Resistance 2k ohm tolerance 10% Temperature -55°C to 125°C Size 20

4k ohm (2K4)

point light display series

It can be simply programmed using the Arduino IDE

High Current Output Stage: 1

Inter-Lock Mode: Press->On

the stronger the force