DuraLED® Rear Position / End Outline Marker Red 12/24V 2309/2BA 959.700-301DuraLED rear position rear end outline lamp featuring red impact resistant polycarbonate lens. Mounting Two hole surface mount with mounting bushes supplied. Suitable for horizontal mounting. Voltage Multivolt for optimum brightness in 12 and 24 volt systems. Power Consumption 3W Protection Reverse polarity and 5000 watt Transient Voltage Suppressor (TVS) Fully sealed against dust, high pressure washing and temporary water immersion. Cable Length Pre

DE-WHDS-18-2 Strain Relief 90deg for Shell Size 18 HD Connectors

Steady state Lamp operates as a continuous ON signal Independent flash Lamp operates from an external flashing system Flash state Lamp operates in the flash mode preselected by the user Blitz state Lamp operates in a burst of quad flashes (pattern 4) The blitz mode overrides the other operating modes and is triggered by switching the blue cable to negative (-)

07/8KA 951

Fog Lamp Insert for 1113

Heat Shrink Red 19

Takes 5x Size 16/42x Size 20 Sockets (Not included)

H1 headlamps with die cast aluminium reflector and hardened glass lens

Box Pack Pre-wired with 2

Mount holes center to center = 88mm

1kg Features • 50 Amp

Up to 5mm thick

featuring Enhanced Definition Technology (EDT)