Grouts for tiles - Determination of water absorption1 Scope This document specifies the methods for determining characteristics for grouts used in internal and external installation of ceramic tiles. This document does not contain performance requirements or recommendations for the design and installation of ceramic tiles. The following test methods are described: Determination of flexural and compressive strength (9. 1); Determination of water absorption (9. 2); Determination of shrinkage (9. 3);

In order to clarify

and users of high FAME diesel blends

Note 3: It is the responsibility of the purchaser or specifier to make the appropriate selection from these aspects

which specifies the HAFM requirements and processes

Prolonged exposure to environmental conditions can cause warping and dimensional changes in wood flooring and panelling

including co-ordination in service (discrimination and back-up  protection)

BS EN 4652-112 on the receptacle with ground block for electrical connectors is useful for:

10 mg/ in the aqueous phase (without chloroform extraction)

This document specifies a gravimetric method for determining the mass per unit area (surface density) of anodic oxidation coatings on aluminium and its alloys

You can ensure that your products are leak-proof and can withstand the pressures which may occur during operation

both to follow the variations in the physical structures of specimens and in calculation of the amount of material necessary to fill a given volume

BS EN 1965-2 provides you with detailed procedures and methods for determining and classifying corrosion to a brass substrate