Shrink chuck 4,5° with cooling channels BT 40 - 08 - 90Application: For mounting tools with straight shanks. Note: Toolholders suitable for induction , contact and hot air shrink units. 3, 4, 5 with h4 tolerance and 6 32 with h6 tolerance For 3, 4 and 5 mm only solid carbide tool shanks must be used! All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m

- The main body is made of aerometal

Measuring contact points are designed to allow measurements near to the bottom of blind holes

Collets sealed for high pressure cooling 120 bar

5 with h4-tolerance and Ø 6 – Ø 32 with h6-tolerance9

d = 40/d = 60: For large diameter face mill cutters with four additional threaded holes according to DIN 2079

If your 3D probe is nevertheless damaged by external force

All collets with outside form DIN 6499 (ISO 15488) can be clamped

0V Battery

Vorschub (Empfehlung): 1

Applicable up to 100 bar

High flexibility: Large holding capacity up to –1 mm

Adapter / reduction / extension for polygonal hollow shank tapers