Hot applied joint sealants - Method for the preparation of samples for testingWhat is this standard about? This document describes a method for preparation of a representative test sample, heating of the test sample and pouring of test specimens for testing hot applied joint sealants for use in joints in concrete pavements for roads, airfields and other trafficked areas.

produced at the terminals of the associated equipment in the range of 30 MHz to 1 GHz

attitudes and insights

users can implement an environmental test for determining the impact of high humidity on components and equipment

What is ISO/TS 22491 - Determination of carbon monoxide in the vapor phase of waterpipe tobacco smoke about

PAS 2012-2 sets out the retail requirements for passenger cars which have been modified to carry wheelchairs

and dispute resolution

that specifies the tolerances on dimensions and form for aluminium and aluminium alloy cold drawn porthole tubes with an outside diameter (OD) from 3 mm to 350 mm (round tube) or with a cross section contained within a circumscribing circle (CD) from 8 mm to 300 mm (other than round tube)

market feedback suggested that organizations wanted something that could be accomplished in multiple increments and to that increment most suited to the needs of the organization

It is intended for use in conjunction with ISO 29463‑1

It applies to the installation of the following gas-fired hot water boilers:

General requirements for procurement documents

the gases are always used in the gaseous form