Male condoms. Guidance on the use of ISO 4074 and ISO 23409 in the quality management of condoms1 Scope This document provides guidance on using ISO 4074 and ISO 23409 and addresses quality issues to be considered during the development, manufacture, quality verification and procurement of condoms. It encompasses the aspects of quality management systems in the design, manufacture and delivery of condoms with an emphasis on performance, safety and reliability. Male condoms are either made from essentially natural rubber latex, in which case the

a part of the ISO 3834 series

depending on associated seal

— 50 coupling pin as defined in ISO 337

Pipe flanges manufacturers and suppliers

Full face and oro-nasal masks are not covered by this European Standard

The performance characteristics of the method determined for waste incincerators cannot be extrapolated to be used for other types of matrix without any further validation work

high content of water-soluble content in paper pulps can have the reverse effect

BS EN 14351-2 identifies material independent performance characteristics

apparent porosity and true porosity of dense shaped refractory products

Component Range Component Range NOTE The values other than LOI are on an ignited basis

This International Standard provides guidelines on the principles of operation and the selection and use of Doppler-based and echo correlation velocity meters for continuous-flow gauging

This International Standard specifies certain characteristics of the oil of bergamot petitgrain [Citrus bergamia (Risso et Poit