Hardmetal burrs - General specifications1 Scope This part of ISO 7755 specifies the common characteristics of hardmetal burrs of various styles, in solid design or with brazed shank. The main dimensions of the cutting part of hardmetal burrs are dealt with individually in ISO 7755 2, ISO 7755 3, ISO 7755 4, ISO 7755 5, ISO 7755 6, ISO 7755 7, ISO 7755 8, ISO 7755 9, ISO 7755 10, ISO 7755 11 and ISO 7755 12.

With the help of BS EN 4165-023 best practice guidance

It does not apply to curtain walls that span across horizontal structural members of floors but is applicable to windows within a curtain walling system

“detailed and faithful scale models” covers

and the related mechanisms to validate the full process of preservation

Testing of the disengagement travel

It is a highly accelerated test which employs temperature and humidity under non-condensing conditions to accelerate the penetration of moisture through the external protective material (encapsulant or seal) or along the interface between the external protective material and the metallic conductors which pass through it

test fuels

Businesses and public administrations providing online services or managing electronic transactions

IRRADIATION conditions

domestic hot water or both

BS EN 12050-2 is the second part of the series that applies to lifting plants for faecal-free wastewater for drainage of locations below flood level in buildings and sites to prevent any backflow of wastewater into the building

The long-term stability of the magnets is discussed in Clause 5