Cylindrical shanks for milling cutters - Dimensional characteristics of plain cylindrical shanks1 Scope This part of ISO 3338 specifies the dimensions of plain cylindrical shanks for milling cutters (of diameters 3 mm to 63 mm). It is applicable to both single ended cutters and double ended cutters. The dimensions of flatted cylindrical shanks and threaded shanks are the subject of ISO 3338 2 and ISO 3338 3 respectively.

covering the design management terminology in use across all sectors of industry

This European Standard covers those aspects to be considered when electrical/electronic/programmable electronic systems (E/E/PESs) are used to carry out safety functions

political organizations and other electoral interested parties through the effective implementation of the electoral quality management system

They are the consequence of the accumulated capital investments and operational expenditures on maintenance and rehabilitation over many years

BS EN 16899 is primarily intended for manufacturers of parkour equipment

Life-cycle/risk management grid

— the reification rules

Glass bottles are made and tested to ensure that they can withstand pressures that occur in use and are well suited for packaging carbonated soft drinks

replacement and repair systems

a fluid may be conveyed under pressure

because the process is fast it will increase repair frequency

from ASE beating with itself and noise factor from multiple path interference (MPI)