End mill holder Weldon SK 40 - 25 - 100Application: For mounting straight shank tools with lateral flat according to DIN 1835 form B (Weldon). Delivery: With clamping screw All holders are made of forged steel Specific, low warpage hardened Surface hardened HRC 58~60 Hardening depth 0,8mm~0,9mm Taper angle tolerance < AT 3 according to DIN 2080 Surface roughness Ra < 0,4 m Tensile strength in the core of min. 800 N mm after DIN All functional surfaces fine machined

With clamping screws

Ersatz-Reinigungs-Propeller Typ 330mm

- With mechanical booster - Clamping force preadjustable by graduation lines

Setting ring not included in delivery - optionally available

For clamping nuts HKS-system

Warranty : 1 year in normal statement

- Bed height H: 0

Standard (over 25mm range)

Parallelism: 0

bei Ø 6 – Ø 32 mm = h229

for clamping holders with coolant channels directly to the cutting edge

- Axial sealed with two O-rings