Specification for chromium-molybdenum steel tube (700 MPa) (outside diameter not less than 12.5 mm) (weldable)

Annex A (normative) Guidance notes for the installation of active radar reflectors

ISO/TS 20758 provides you with the test conditions

It’s recognized as good engineering practice in most countries and is a regulatory requirement in an increasing number

Clause 6 and Clause 7 regarding the requirements for road recovery vehicles and their equipment have been updated

some of the requirements of this standard may still apply and may be specified in other European Standards

The use of electricity in play equipment

and also expedite any revision necessitated by changes in clinical practice or as a result of developments in technology

BS ISO 21932 Buildings and constructed assets

Updating of preliminary information and documents specifying the PRPs and the HACCP plan

9 Provisions against explosion hazards

to enable the plan owner to harmonise its plan for both documents

The extent of BS EN 60728-11 work is from the antennas and/or special signal source inputs to the headend or other interface points to the network up to the terminal input of the customer premises equipment