Plastics. Polytetrafluoroethylene (PTFE) semi-finished products - Requirements and designation1 Scope This part of ISO 13000 specifies the requirements for processed unfilled polytetrafluoroethylene (PTFE) products, which may occur in several forms. The PTFE used to make the semi finished product is described in ISO 12086 1 and, as provided in ISO 12086 1, may contain up to 1 % of a comonomer. The PTFE used to make the semi finished product may be virgin, reprocessed or recycled resin. The addition of up to 1,5 % by mass of pigment or colorant

Measurements and tests that are solely used for the verification of safety requirements of equipment for EH or for EPM are outside the scope of this standard and are covered by the IEC 60519 series

Plastic materials which contain additives such as plasticizers or colorants

What is ISO 15202‑1 about

PD IEC/TR 62443-2-3 on patch management of security for industrial automation and control systems applies to:

It is based on methods developed

BS EN IEC 62496-4-1 helps you to do this by measuring the intensity and spectrum of light-emitting materials such as compound semiconductors and quantum dots

BS 7967-1:2005 is intended to be used in conjunction with  BS 7967-2

and these rights and legal protections are respected by the organization

LPG cylinder transporter

This part of ISO 16143 specifies requirements for stainless steelwire for common use for which no product standard exists

BS EN 15048-2 provides guidance on technical requirements for bolting assemblies

This part of ISO 16000 specifies a test method for the sampling and analysis of the phosphoric acid esters in indoor air and in test chamber air through gas chromatography/mass spectrometry