Plastics. Thermoplastic polyurethanes for moulding and extrusion - Designation system and basis for specifications1 Scope This part of ISO 16365 establishes a system of designation for thermoplastic polyurethane elastomers, which is based on ISO 1043 (all parts) and ISO 11469. The designation system may be used as the basis for specifications. The designation system is applicable to all thermoplastic polyurethane elastomers. It applies to materials ready for normal use in the form of powder, granules or pellets, unmodified or modified by colourants, fillers or

BS 7121-5:2006 covers subjects such as the selection of tower cranes and planning the installation – including site specific design work

What is BS ISO/IEC 27001

hazardous situations and events relevant to symmetric wedge sockets for terminations for steel wire ropes

and floor flatness are all included in BS EN 15635

NOTE 3: The systems specified in this part of BS 5446 are specifically intended to give warning in the event of a fire

Ready-to-occupy workplace

BS 5906:1980

Note: BS EN 61073-1 does not cover test and measurement procedures

• Immunity to interfering signals

For some of the requirements given in this document

This document describes RF transmission for fully digitalized broadcast and narrowcast (limited area distribution of broadcast) signals over FTTH

6 Sound power level determination