Simplex Tyco 4099-9001 Pull StationThe 4099 9001 single action manual station requires a firm downward pull to activate the alarm switch. Completing the action breaks an internal plastic break rod (visible below the pull lever, use is optional). The use of a break rod can be a deterrent to vandalism without interfering with the minimum pull requirements needed for easy activation. The pull lever latches into the alarm position and remains extended out of the housing to provide a

including the SD505-PHOTO photoelectric smoke detector and the SD505-HEAT heat detector

The personality code downloaded to the module by the loop controller during system configuration determines the module’s function

Dual Isolation Technology

A cover tamper feature indicates a trouble signal for a removed or improperly installed sensor cover

cost effective

Horn control that can be select to be temporally coded

Optional UL listed red wire guard is available for semi-flush or surface mounting

Its robust construction supports long-term performance

This virtually indestructible cover (slotted for sounder/strobe unit) is specifically designed to prevent vandalism and accidental damage to a signal unit of a fire alarm system

Operating Humidity Range: 10% to 93% Relative Humidity

Dual electronic thermistors add 135°F (57°C) fixed-temperature thermal sensing on the 2951TJ

dual voltage (25/70 VRMS) capability and field selectable taps from 1/8 to 8 watts