BS EN 4878-003. Aerospace series. Polytetrafluoroethylene (PTFE) - Part 003. Paste extruded

NOTE 1 Solid wall multilayer pipes with different formulation throughout the wall and foamed core pipes are covered by EN 13476‑2 [1] (see also CEN ISO/TR 27165 [2])

The designation of the microstructures is based on morphological appearance

The needle-flame test is intended to simulate the effect of small flames which may result from fault conditions within the equipment

Manufacturers of protective gloves

or if the wearer collides with another player

a method for determining surface resistance

This International Standard specifies test methods to determine the quality of data on recorded media and provides specifications enabling end-user organizations to monitor data quality and ongoing conformance with the error limits required for its class identified by the manufacturer of the drive/media

The term “paintability” is used throughout this document and is a generic term to refer to the application of paint or a coating to a sealant

BS EN IEC 61482‑1‑1 on protective clothing for thermal hazards is useful for:

The linear expansion of the blocks depends on the sampling direction due to anisotropy

restructures

IEC 61156‑6 and IEC 61076‑2‑101 type D