RPM R/C Products - Rear A-arms for the Associated B6 & B6DRPM Rear A arms for the Associated B6 & B6D are designed with the same principles as their Flat Front A arms (RPM #81372) & Gull Wing Front A arms (RPM #81422). With stock A arms, the amount of slop at the hinge pins can cause your suspension settings to wander. RPM hinge pin holes are held to strict tolerances, with no more than 0. 0005" to 0. 001" (. 013 to . 025mm) of clearance, an improvement of nearly 300% over stock! RPM B6 B6D A arms are 4. 75

1/10 scale EP buggys and Short course trucks (such as Gmade R1

Mounting hardware included

in the USA

ensuring long life and the broadest working spectrum for almost all track conditions

Reeper Truck Body (Green) Painted

'- One (1) bulkhead Cover

Much stiffer and truer than molded nylon spur gears

Pre-drilled 9x50mm mounting pattern for winch

Will need bearing from the stock steering

Inside Ribbing: Provides sidewall support and stability

Center Drive Shaft: SCA-1E

then Hand air brush painted