PETITE LOOPED LACE OVAL DIE SET - Gina Marie DesignsLargest die measures 5. 37x4. 25 Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut

Keeping one plate new at all times helps the die not need to flex to two plates and only one

This die cuts best FACE UP and at an ANGLE

The largest oval measures approximately 4

That means to run them in by a corner first and not flush into the machine

This set has a little yellowing on the photopolymer but will not effect stamping

PLEASE READ -

1/4 inch spacing between the pierce layers

THEY SHOULD BE BRAND NEW BUT THERE COULD BE A FEW IN WHAT WE ARE SELLING THAT MAY HAVE A STAMP OR TWO IN THE SET USED

Measurements

These dies are similar to our scalloped frame dies except the outer cutting edge has been removed

AS SHOWN ON THE EXAMPLE THIS DIE ONLY PIERCES THE DOTS IN THE SHAPE OF THE DIE

EXAMPLE CARD SHOWS THE PIERCE DOT LAYERS USED IN THE CENTER OF THE CARD