1964-1972 GM A-Body Tubular Front Lower A-Arms, Delrin, 1/2" Taller Ball Joints1964 1972 GM A Body Tubular Front Lower A Arms, Delrin, 1 2" Taller Ball Joints

greaseable polyurethane bushings and zerk grease fittings all combined to make the best arms on the market

Don't reuse your old rusty bolts when installing aftermarket upper A-arms when you can replace them with new ones

Red Line fullsynthetic D6 ATF is a lower viscosity version of the D4ATF and is designed for better fuel efficiency in CAFE testing

These control arms are a direct replacement that minimizes wheel hop

The stock eccentric bolts provided by Chevrolet for small toe and camber adjustments tend to slip under high cornering loads

Supplied is (8) 12 mm 10

Idemitsu K17 (Jatco 3100) WSS-M2C922-A1

which can be done track side in less than a minute per side – just raise a front corner (tire off the ground)

These have a maximum

3031 - 1982-1992 F-Body

This unit is built using DOM mild steel tubing

Used in applications with wider bearing clearances