Method of test for determination of the punking behaviour of phenol-formaldehyde foam

The products covered by BS EN 61236 may have an impact on the environment during some or all stages of its life cycle

BS EN 16314 contains requirements for gas valves integral within the meters and controlled by an AFD where the capacity of the gas meter does not exceed 10 m3/h

BS 5261-3 provides the textual and marginal marks used in correcting proofs

Why should you use BS EN 3866 - Ream and surface ripple of glass in aerospace

Vibration risk reduction is an integral part of machinery safety

BS EN 3943 provides the material designation

including the context of multiple units

Tests required by a higher level of compliance take precedence over similar tests with a lower level of compliance

BS EN 15183 on corrosion protection test and repair of concrete structures is useful for:

Data sensors and interface applications

This Part 403 of IEC 60811 specifies the method for the ozone resistance test

— geometrical accuracy