Implants for surgery. Components for partial and total knee joint prostheses - Classification, definitions and designation of dimensionsPartial and total knee joint prostheses are designed to transmit loads and allow movement under high stress conditions. They are intended to replace anatomical structures and provide structure and function to provide as closely as possible the attributes of the normal natural joint. The structure and functions required in a specific implant depend on the amount of anatomical structure or function which is attenuated or absent, and a system of

as more products are combined to provide total solutions

operating table

NOTE: This standard and others that supplement it specify additional test requirements for equipment operating outside the standard temperature range

environmental and health information

NOTE To avoid water penetration in masonry walls special tests adjusted to local climate might be needed

The primary application is to provide a common basis for evaluation of odour emissions in the member states of the European Union

hex cap bolts

Implementation of BS EN 15696

you would like to be sure that your products are safe and effective

A huge range of nanomaterials has already been produced including nanotubes

Immunity to pattern S1 for DVB-H

surface treatment on the inner ring solely