Rivet shank diameters1 Scope This International Standard specifies two series of shank diameters of rivets for general use, except blind rivets, in the range from 1 mm up to and including 36 mm.

Road vehicle body shops

5 (33 % voltage reflection coefficient)

customer satisfaction

NOTE 3: In light of alloys and ‘wheel loss’ the standard reflects that vehicle manufacturers’ instructions take precedence over generic advice contained in the standard

Suppliers of balustrades and handrails

are required

specifies requirements for the approval testing of welders to be engaged on the manual or semi-automatic fusion welding of those ferritic steel or austenitic stainless steel fabrications for which the welding procedure does not itself have to be approved

BS EN 13402-3:2004

It applies to cold-rolled sections for general use (standard sections) produced from steels conforming to BS EN 10025

Convexity - Concavity

the DS(s) applicable to this SS are numbered in accordance with CECC 00 700

Risk management in the life cycle