ISO and Health Canada intense smoking parameters - Examination of factors contributing to variability in the routine measurement of TPM, water and NFDPM smoke yields of cigarettes1 Scope This Part of ISO TR 19478 extends the analysis reported in ISO TR 194781: 2014 and reports additional studies focused on the conclusions i) and j) from that Technical Report. It identifies and assesses factors impacting on the measurement of smoke TPM, NFDPM, nicotine, water, and carbon monoxide yields when increasing the intensity of the puffing regime from that specified in ISO 3308: 2000 to the regime specified in Health Canada Method T 115.

drive and control units intended for use in paper making and shall be used together with EN 1034‑1:2000+A1:2010

This test method helps in determining the withstand of the voltage in these switches

sub-clause 4

BS 6972 provides manufacturers with the conditions of use

BS 1186-2 focuses on joinery

may be retested or evaluated to show conformity with IEC 61000-3-11

Table 3 – Sampling plan together with numbers of permissible defectives for qualification approval tests

5  Evaluation management concepts

Annex A (informative) Facility management brief for a refurbished facility (examples)

PPM enables users of a PISN to register at any suitable terminal (wired or wireless) within the network for the making and/or receiving of calls

Note 1: ISO 19353 does not apply to:

ISO 8434-1 discusses tubes that are rigid conductors and hoses that are flexible conductors