Plastics. Styrene-acrylonitrile (SAN) moulding and extrusion materials - Preparation of test specimens and determination of properties1 Scope This document specifies the methods of preparation of test specimens and the test methods to be used in determining the properties of styrene acrylonitrile (SAN) moulding and extrusion materials. It gives the requirements for handling the test material and for conditioning both the test material before moulding and the specimens before testing. This document gives procedures and conditions for the preparation of test specimens and procedures

This document applies to analyzers using membrane covered amperometric sensors

the OLOP and DLOP for flow transmitters with blocks and properties are to be found in BS EN 61987-12

and behaviors in telehealth environments

Fuel suppliers

it may be necessary due to national regulations or depending on user requests to set the values of the prescribed parameters differently when the alcohol interlocks are in use

within a space programme or project and in accordance with the other relevant ECSS standards

The model assumes the link components have been designed such that baseline wander is negligible

BS EN 61290-3-1 describes the test method i

and pavement ensuring the strength

Note: Requirements for float operated valve assemblies and methods of fixing cisterns are not specified in BS 7357

10/ISO 4902 equipment with V

This document applies to belts and lanyards intended for the purpose of work positioning or restraint