6 x 4R7 Ballast ResistorFor use with low impedance injectors. Compatible with injectors with impedance between 2 and 6 Ohms. Please contact us if you are planning on using injectors with an impedance of less than 2 ohms. Includes set of 6 x 4. 7ohm 25w resistors mounted to a heatsink. These are also sold in a set of 4. Note that injector ballast resistors get quite hot at high injector duty cycles. These should stay mounted on the supplied heat sink and be bolted to the

Aux 9                EThrottle - can't be used as an Aux Out

E-Throttle Connector

Compatible with Link CAN Connection Cables

New WEIPU CAN connector

1 x Mounting Bracket

Aux 13                Auxiliary Output

Also adds the ability to connect to the ECU over a network

Vipec i88 (Loom A/Pin Kit A also required)

The Link 2

G4+ and G4 Xtreme (Loom A also required)Link G4+ Thunder (Note: Loom A and connector kits C and D may also be required)Link G4+ Storm Black (Loom A also required) – Note: Loom B is not required for the older Silver or Blue G4 or G4+ Storm modelsVipec V88 (Loom A also required)Vipec i88 (Loom A also required)

have a look at the S13X PlugIn listing

peak and hold injection or e-throttle