Ceramic tiles. Grouts and adhesives - Test methods for adhesives1 Scope This part of ISO 13007 describes the methods for determining the characteristics for adhesives used in the installation of ceramic tiles. The following test methods are described: determination of open time (4. 1); determination of slip (4. 2); determination of shear adhesion strength (4. 3); determination of tensile adhesion strength (4. 4); determination of transverse deformation (4. 5).

It does not include requirements covering the electrical safety of electrically heated component parts or their associated equipment1)

Designers of LC-PC duplex connector

radiation detection

The attributes and definitions of fibres covered in this technical report are given in Table 1

The produced paper should be targeted to resist water or moisture

8 and 9 of RID

This standard does not cover the installation of these floor coverings on access flooring

mains frequencies with the use of a starter

which are treated as personal care robots and is limited to earthbound robots

The scope of the Report is limited to the specification of standardised messages

10 Fully Enclosed Viewing Areas

tracks or signals