SUPERLIGHT RACE PIPE (RACE CATS)Introduction After the success of our 991 GT3 based exhaust products we have turned our attention to the mighty GT2 RS. The Forced induction engine requires a slightly different approach when tackling the exhaust development due to much higher EGT's however through use of high quality motorsport materials we have developed a range of direct replacement exhaust components which not only accentuate the factory exhaust sound but reduce weight and

Required Parts

Inconel 625 Side & Valve Sections

718 GT4 / Spyder / RS

Direct Replacement

Improving the rear end look the JCR Exhaust Tips increase the tip diameter to 102mm to nicely fill the factory exhaust cut out

Custom specced JCR Springs

The revised wing position our uprights offer improves efficiency by increasing the effectiveness of the factory rear wing (repositioning up and back) resulting in a good aero balance with overall lower AOA (angle of attack) resulting in less drag

Simply replace the factory valve motor actuator onto the JCR valve delete section and the car will run perfectly without any concerns of engine lights

No Silencing

The JCR Titanium Bolt-On Exhaust Tips are lighter than the OEM 991 GT3 / RS exhaust tips

We're excited to launch our limited edition 'one drop' Neptune Blue t-shirt to celebrate our new JCR GT2RS MR makeover

especially with the roof removed