ER-Collet with seal for IC ER25 | 430EH | < 15µm | Ø 15Application: Collets sealed for high pressure cooling 120 bar with IC DIN 6499 B (ISO 15488 B) ER system Note: Only nominal size d can be clamped (applicable up to 120 bar). In order to achieve an optimum sealing the tool must be clamped on the complete length of the ground drill of the collet.

For sealing tools with internal cooling in collet chucks

800 N/mm² after DIN

Setting ring not included in delivery - optionally available

PSK = PSK 50

Jaw parts in contact with the workpiece press the workpiece onto the surface

From DCONWS = 25 on two clamping screws

integrated in the adapter

There is no need to set the zero position each time the caliper is used as the origin setting is retained even when the caliper is switched off

- Calibration of the angular position of spindles of milling-turning centres

edge radius 1 mm

For the chucking of quick change adaptors for taps

clamping depth = 50