Bondtech CHT™ Coated Brass Nozzle (Volcano Compatible)In stock, ready to ship. These are nozzles for High Flow applications ALERT : Avoid Cold Bondtech CHT Nozzles Change Heat up the heat block up to 280C, or at least above 250C, before removing or tightening any Bondtech CHT nozzle. Use at most 1. 5 Nm torque. They are manufactured by Bondtech in house, and will fit the following hotends blocks: E3D Volcano blocks Other Volcano type blocks Artillery Sidewinder X1 and X2 Anycubic Vyper FLSUN Super Racer

Free shipping in the continental US

12x M3 Buttonhead Screw

Signal levels are 3

Nozzles can be individually adjusted in height for an easy setup experience

we’re using good old RAMPS 1

Meet our new MinMax silicone heaters for Micron & SaladFork

15mm - The ultimate nozzle for ‘wow-factor’ tiny printing - recommended for use with high flow materials like MG94 and MatX

RGB LED power supply pin protected against short to GND

Specifications for GF45 series - Included in v2

Termination Style:

reducing print artefacts

Not all 3D printers allow firmware updates