Non-destructive testing of welds. Ultrasonic testing. Acceptance levelsWhat is BS EN ISO 11666: 2010? BS EN ISO 11666: 2010 looks at the non destructive testing of welds. This includes ultrasonic testing to specify acceptance levels for full penetration welded joints in ferritic steels. The standard gives practical recommendations to help users examine ferritic steel welds with thicknesses from 8mm to 100mm, but can also be used for other types of welds, materials and thicknesses above 100mm. The nominal frequency of

This Part of this European Standard specifies a concise procedure for conducting thermal performance tests

This standard does not cover the power supplies for self-contained smoke alarms or the battery powered parts of wire-free detection and fire alarm systems

test methods and marking of automatic burner control systems and programming units and their associated flame detector devices for gas burners and gas burning appliances with or without fans

recommendations and guidance material which explains the relevance of UKLeaP and sets BS 8788-2 and BS 8788-3 in context

Fluxes for the single and two run techniques are classified on the basis of the two run technique

maintenance or repair

Good quality control helps companies meet consumer demands for better products

2 Stacking

The products covered by BS EN 10326 are mainly used where minimum yield strength and corrosion resistance are the most important factors

4 Test method

important modification to existing lift installed before the publication of this standard

Note: BS EN 13612 does not apply to specific evaluation plans for certain IVD MDs or specific use