Diesel engines. 60° female cones for high-pressure fuel injection components1 Scope This document specifies the dimensional requirements of end connections for high pressure fuel injection equipment components, used on diesel (compression ignition) engines. It is applicable to externally threaded 60 female cones (see Figures 1, 2, 5, and 6) and intended for use with high pressure fuel injection pipe assemblies with tube outside diameters of: up to and including 12 mm for integral female cones (see Table 1); and up to and

HV and EHV power systems

It describes the potential environmental stresses and specifies tests and requirements recommended for the specific mounting location on/in the vehicle

It is imperative that a connector is able to withstand extreme temperature changes simulating the worst possible conditions of storage

Guidance on using informative annexes

BS EN 15213-2 is the second part of the multiple series document that is applicable to intelligent transport systems

or fully hydrogenated fats

BS 6031 is non-conflicting complementary information (NCCI) to BS EN 1997-1

This part of ISO 21587 specifies traditional ("wet") methods for the chemical analysis of aluminosilicate refractory products and raw materials

it does not take into account

Methods of test for reinforcements

What is ISO 14120-General requirements for fixed and moveable guards about

a traction battery and double-layer capacitors