STAINED GLASS BORDER CIRCLE DIE SET - GINA MARIE DESIGNSMeasures 3. 85 inches largest layer Tips and tricks for die cutting When using steel dies I like to reccomend for machines that need 2 plastic cutting plates to keep one new and use the other to cut into. Make sure you are flipping the one your cutting into to help reduce the wave that will happen with excessive cutting. Keeping one plate new at all times helps the die not need to flex to two plates and only one. I find you typically get a better cut

This is very important not only to get a good cut but to keep your machine in good working order

Sounds crazy but removing that trash paper can allow you machine to cut down the slightest bit more helping you get a cleaner cut on very detailed dies

PLEASE NOTE this die is a smidge smaller than a 4

As you can see this is a very detailed die

4x4 in size

Die is the 3 flower burst background plate die (one solid piece)

Die is approx 5

Largest layer approx 4 inches

Largest layer measures approx

Prior to shimming a die if needed try to remove the "outer paper" and run the die back through your machine

Largest layer is approx 4x4

Largest layer measures 4x4